How to Reflash Nissan ECU Update Procedure with Consult III Plus

V75 Consult-3 Plus for Nissan Nissan Diagnostic Tool Support Programming
Software download link : https://mega.nz/file/19wB2SBC#B7VUf_wahxq65PCo4zznlQD515NAWrZPrMgj4vJ8C40

Top 7 Reasons to Get Nissan Consult 3 Plus:
1. Support Nissan till year 20181.Consult-3 plus = Consult-3 for Nissan + Consult-2 for Nissan
2.Software Version: CSP Software Version : CSP V41.10; Programming Data Version : plus_V75
3.Supports all the models of the Nissan and Infiniti from 1996 to 2018, with all Consult II & III functions .
4.Calcaulate the password for the new cars till year 2018 with NISSAN Password.
5.Supports ECU Programming without card
6.Can be installed on Windows 7, Windows 8, Windows 10
7.Suppored Languages: English, Chinese, Finnish, French, German, Greek, Italian, Japanese, Portuguese,Russian, Spanish, Turkish, Thai, Czech, Polish, Hungarian

Nissan Consult III Plus scan tool will be needed to perform the process of reflashing/reprogramming Nissan ECUs. This process works for any computer on any Nissan vehicle and is the same process if you use the factory tool (Nissan Consult) or a J2534 tool.

A Consult3+ clone can be used to flash ECU, but only work on Nissan pre-2016. For newer Nissans, the reflash file needs to be purchased for the Nissan website and is an extra purchase to the Nissan subscription purchase you also need to make.

On some vehicles you will need to email Nissan to have the file sent to you, these vehicle do not require you to purchase the file but do require the subscription purchase.

How to Reflash Nissan ECU Update Procedure with Consult III Plus

Model example: Nissan Maxima 2016
* Reprogram ECU
* Throttle valve closed position learning
* Idle Air Volume learning
* Accelerator Pedal Closed position learning
* Confirmation Start up Engine
* Erase DTCs
* Completed

Detail:

Select vehicle information, Go to Measurement Mode

Read Precaution and confirm

Read VIN and confirm
Cumminicating with vehicle


Select Engine system->Reprogramming

Save operation log

Read and confirm operation procedure

Check vehicle detail information and confirm

Confirm vehicle condition. Remove the terminal caps of the battery and connect battery charger to battery. Adjust the battery charger output so that the vehicle voltage is between 12.0V and 13.5V.

Confirm the RESULT is ok and confirm vehicle conditions listed on the interface



Transfer data among computer, Nissan Consult 3 plus and vehicle

Reprogramming is completed.

Perform throttle valve closed position learning

Fully release the accelerator pedal. Turn ignition ON and turn off. Then count download of 10 seconds starts.

Make sure throttle value moves during count down of 10 seconds by confirming the operating sound.

Turn Power switch/ignition SW to ON position.

Perform Idle Air Volume learning

Perform Accelerator Pedal Closed position learning
Turn ignition switch to OFF position and hold it for 10 seconds or more

Turn ignition switch to ON position and hold it for 2 seconds or more

Repeat the procedure once or twice

Turn ignition switch to OFF position

Confirmation Start up Engine
Confirm the engine keeps starts and idling normally.

Erase DTCs

The ECU reflash update procedure is completed.