The SDD software connects to the vehicle’s electronic control modules, allowing it to retrieve and interpret data from various sensors and components. It provides real-time access to critical information such as fault codes, live data streams, and system status. This comprehensive insight helps pinpoint the root cause of malfunctions, ranging from engine and transmission issues to electrical and electronic faults.
JLR DoiP VCI SDD Pathfinder Interface for Jaguar Land Rover from 2005 to 2023
Operating system: Windows 10 or 11 (64-bit)
CPU: Core i3
Memory: RAM at least 4GB
Hard Drive: at least 10GB available
SDD JRD Supported Vehicles
The JLR SDD software supports all Jaguar and Land Rover models from 2005-2016:
Land Rover: L316, L319, L320, L322, L359, L538
Jaguar: X100, X150, X202, X250, X350, X351, X400
How to perform RCM (Restraint Control Module) programming using JLR SDD V164 software
1. Click to Choose this session type
2. Click “Continue”
Loading Recommended Candidates……
3. Click “Session”
4. Click “Recommendations”
5. Click “Service Functions”
Select “Configure new modules – Restraints control module”
Click “Run”
Operator question
Ensure a new module has been fitted to the vehicle before continuing with this procedurePress the confirmation tick to continue or cross to exit.
6. lgnition state
Set the ignition switch to on (position 2).
Waiting for system to stabilise
7. Operator question
IDs applications will be disabled if the vehicle battery voltage isbelow: 12.50 Volts.
current measured battery voltage:14.70 v
Ensure an approved battery charger is connected.Press tick to continue
Press the cross to exit.
8. lgnition state
Set the ignition switch to off (position 0).
9. lgnition state
Set the ignition switch to on (position 2).
10. Module initialization
Please wait while the module initializes.Press the confirmation tick on completion.
11. Learning the vehicle identification number.
12. Clear the fault codes.
13. lnitialising
14. CLICK “DTCs”
