This instruction will show you guide on how to reset service oil and inspection by ODIS for 2017 AUDI Q3.
Preparation:
VAS5054A/VAS6154 ODIS 6.10 Software Download, Update and & Installation Guide
Newest ODIS-E Engineering 12.1.1 & 9.0.4 Free Download
How to Install ODIS-Engineering 12.1.0 Diagnostic Software
Procedures:
Connect ODIS to vehicle OBD port, then running software.
Click “Start Diagnosis”
Select correct basic vehicle characteristics, click “Adopt”
Click “Without Job”
Click “Address”
Click “Fault Memory list”
Click “Information Control Unit”
Click “Done/Continue”
Still click “Done/Continue”
Click “Done/Continue”
Click “Special functions”–>”17-Inspection with oil change-10000KM”–>”Perform test”
Click “Yes”
Click “Done/Continue”
Inspection service was successfully, Click “Done/Continue”
Test finished, click “Done/Continue”
Click “Control units”–>”Control unit list”–>”0017 Dash Board “–>”self-diagnosis”
Select “0017-Dash Board”–>”Adaption”
Input “sia” for Filter, then input “180”
Click “Yes”
Click “0017 Dash Board”–>”Diagnosis”–>”Save”–>”OK”
After saving, click “Data”–>“Stop”–>”Without saving”
Function is ready
